|A rather unique sewing box with castors, and one that is quite as convenient as unique. This could also be a craft supply box, toy box or school supplies box. So many possibilities since it is basically a box on wheels.
The material is walnut and ash. The posts are walnut and the slats and top rail ash. Both are finished in their natural colors.
You will need:
- 4 posts, 1-1/2 in. in diameter and 15 in. long, walnut.
- 1 bottom, 3/8 by 16-1/2 by 16-1/2 in., S-2-S, walnut.
- 4 top rails, 3/8 by 1-1/2 by 20 in., S-2-S, ash.
- 4 under rails, 5/8 by 3/4 by 20 in., S-2-S, walnut.
- 72 slats, 1/8 by 5/8 by 6-1/2 in., S-2-S, ash.
In ordering the stock it will be wise to combine the lengths of pieces having like widths and thicknesses.
If not possible to secure doweling of the diameter indicated for the verticals, it is an easy matter to take a square piece of stock, lay it off and work it into an eight-sided prism. After this, the arrises may again be planed until it has 16 and then 32 sides. The rest may be removed with sandpaper. Or it is possible that curtain pole stock will be available. Saw these posts to length and leave the ends square.
Sewing Box Construction
Square up the stock for the other parts. Work the bottom piece to a 16-in. square. The rails are not to be squared on the ends but are to be mitered each in turn. The bottom is fastened to the posts by metal brackets.
Chisel out recesses in the posts so that the bottom may be inserted. Insert the corners and use glue and nails to hold them in place. Place the lower of the two top rails, notching out the posts as is necessary to bring the inner edge of these rails in position. Fasten to the posts. Miter and place the top rails. The slats, it will be noted, are fastened to the bottom from the outer side and to the lower of the two top rails from the inner side. Brass-headed tacks such as upholsterers use are required.
In finishing, sandpaper all parts and then apply a coat of boiled linseed oil. Allow this to stand a half hour or so and then wipe the surface clean. After this has dried thoroughly apply a thin coating of shellac and allow it to harden. Sand the shellac when hard with No. 00 sandpaper and then apply several coats of wax, polishing in the usual manner.
Two pairs of castors will add to the ease with which the box may be moved about.